Get Accurate Prints - Calibrating Your SLA 3d Resin Printer
Nerdtronic Nerdtronic
66.1K subscribers
109,104 views
0

 Published On Feb 5, 2020

My Phrozen Transform 3d Printer was printing about 2% off in scale. I'll show you how to calibrate any LCD or DLP based SLA resin 3d printer so that it prints out to exact scale. I also figured out that the default settings in ChiTuBox for the Transform, as well as the settings Phrozen gave us for the Transform - are wrong. And I tell you what they should be.

Note that in the video at the end when talking about the 5.5 inch screen I misspoke and read the 6.8 as 8.6.. and then for 68 I say 86. But the numbers on screen are correct - 6.8 and 68.

Some of my other normal supplies. To support my channel please visit these affiliate links:

Digital Caliper - https://amzn.to/32Ar9iX

Food trays that I put in front of my printer to catch parts on. These are ridgid and therefore a little better at holding liquid and spills than the ones in my resin handling video: https://amzn.to/3lo3bQK

Rubber Mats - a lot cheaper than wham bam - https://amzn.to/3pmhfws
Metal Funnels - https://amzn.to/39ZU56y
IPA - https://amzn.to/2T0uFzS
Spray Bottles - https://amzn.to/2T2q7t2
Nitrile Gloves - https://amzn.to/2Tm6T0c
My Mask - https://amzn.to/3cgvWL5
Tea Strainer for Recycling IPA - https://amzn.to/3c7ZJFr

And this is my favorite resin: https://amzn.to/3kln4qe

show more

Share/Embed