Published On Sep 23, 2020
It's taken me a long time to get there but I am finally able to engrave brass on my CNC to a level of detail needed even for small text (which is the most difficult). I've been able to get this detail by using a few tips that beginners might not know, so here they are;
0:00 Backstory of why I want to engrave on my CNC
01:00 Book recommendation for anyone interested in foil stamping etc
02:04 Examples of engraving and relief carving
03:00 Example of detail that can be achieved in brass
03:24 Tip #1
04:17 Tip #2
06:00 Tip #3
07:13 Tip #4
07:50 Tip #5
09:20 Tip #6
10:26 Tip #7
10:57 Tip #8
1/4" Engraving Bits - https://bit.ly/3hRXOXr
1/4" Chamfer Bits - https://bit.ly/2RQE5wB
Great book for foil stamping, embossing inspiration - https://amzn.to/3kTATgl
Winston Moy Video on calibrating your CNC - • Shapeoko 3 Squaring, Tramming, and Ca...
💚 Support me 💚
Patreon - / thisdesignedthat
---------
GEAR USED:
BEST CAMERA UNDER $1K (US) https://amzn.to/2GpRCIw | (UK) https://amzn.to/2Xg7dOo
FAV LOW LIGHT LENS: (US) https://amzn.to/2QT7aJ5 | (UK) https://amzn.to/2v7HbRr
FAV MACRO LENS: (US) https://amzn.to/2VcOa6O | (UK) https://amzn.to/2V12pPA
GOOD VLOG MIC: (US) https://amzn.to/2Sdr12I | (UK) https://amzn.to/2DfVyHU
AMAZING LOW COST LIGHT: (US) https://amzn.to/2ElMJxg | (UK) https://amzn.to/2v8A23u
120CM QUICK SETUP SOFTBOX: (US) https://amzn.to/2IAOBDf | (UK) https://amzn.to/2F6jcrd