I decided to build another enclosure similar to my previous one but with some improvements. I use easy to get materials and make the build as simple as possible. Only basic tools required.

The main body is made of only 5 pieces. The base is 26x26 inches as is completely square.
The 2 side pieces are 26 inches long and 24 inches tall with an angle that starts 12 inches from the back. The back is 27 3/8 wide (using 3/4 material adds the overlap) and 24 inches tall. The front piece is 7 inches tall and 27 3/8 inches wide. The angled front starts at 12 inches from the back and runs to 7 inches from the bottom.

For templates that I have made, check out my Etsy shop. I build files for projects and tools for laser engravers.
https://www.etsy.com/shop/TheClackShack

The links below are affiliate links that will direct you to the product in this video. If you use this link for a purchase, I will receive a commission from the purchase. I remain unbiased and honest in my assessment as always.

XTool: https://www.xtool.com/?ref=TheClackSh...
Comgrow: https://comgrow.com?sca_ref=2392321.3THJ0z0mmv

D1 10 watt bundle that I have on Amazon: https://amzn.to/3sJRPMC

Kregg pocket hole bit
https://amzn.to/3SImUvv

Dewalt 20 volt cordless saw
https://amzn.to/3SO68Lp

Kregg plywood pocket screws
https://amzn.to/3zXNbgA