I make an Industrial Style Wall Coat Hook using Rebar - using my R.M.Williams Belt as inspiration, the rebar rod gives it the industrial decor look. It was a good welding project for me, I used heat in this project so I would not have to hammer and dent the steel while I bending it.
R.M. Williams is an Australian footwear and clothing company.

The big steel flat bar is 6mm thick, and 25mm wide. The small steel flat bar is 6mm thick, and 16mm wide.
The Rebar is 7mm rebar
Main tools used, Welding Magnets V-Pads, MIG welder, angle grinder, LPG blow torch, and a Drill.

Tools / Supplies, I often use are.

Marking out Tools
Markal Silver-Streak Metal Marker Round: https://amzn.to/3mTJDHt
Milwaukee 4pk Inkzall Black Ultra Fine Point Pens: https://amzn.to/2WKKpeE
Milwaukee Inkzall Jobsite Fine Point Black Permanent Marker 12 Pack: https://amzn.to/3kHrXfo

Locking Pliers – Vise Grips
MILWAUKEE 10” Locking Pliers, Curved Jaw: https://amzn.to/3zzJH2u
Milwaukee 6" Long Nose Locking Pliers: https://amzn.to/3jyVLeS
Milwaukee 6” Locking Clamp Regular Jaws: https://amzn.to/3jB94eI
KNIPEX Tools Long Nose Grip Pliers: https://amzn.to/3ByD1SP

Magnets
Magnetic V-Pads Kit, Magnets On Both Pad Face & Bottom: https://amzn.to/3DCya4W
Mini Magnetic Fabrication Square Magnets Angles: 30°, 60°, 45°, 90°: https://amzn.to/2WN9Fkr
“L” shape Corner Square Magnets 12°, 90° & 60° Angle Setting: https://amzn.to/2YaZXsU

My camera set-up.
Canon EOS M6 Mark II Camera 15-45mm Lens: https://amzn.to/3DNnn83
VideoMicro Rode Compact On-Camera Microphone: https://amzn.to/3QkUBnK
Camera Tripod Vanguard Alta Pro 2: https://amzn.to/3yB8hP5

The Brand of the Drill bits, and cutting/flap discs, is "Alpha" If you can't get them at your local hardware shop, here is a link to Alpha Tools: https://alphatools.com.au

As an Amazon Associate, I earn from qualifying purchases. This means that if you click on one of the product links, I’ll receive a small commission. This helps support the channel and allows me to continue to make more videos like this one. Thank you very much for your support!

►►Subscribe to our Channel for more videos ►► http://bit.ly/2ULxLJogavinclark
Always use all the correct safety gear, and use your tools safely, I am not a good role model for this.

Hope you found something of use in my video or at least found it entertaining.
Gavin Clark DIY

Note: When you bend metal/rebar, you naturally weaken it. Bending it cold will normally cause fine cracks, and it may even break if you put enough strain on the rebar or bend it in the same place too many times. Do not rely on cold-bent steel/rebar to support a load.