In first experiment FDM vs SLA I used the most popular and budget materials, like Elegoo Water Washable Photopolymer resin and PLA filament. A lot of comments suggested that I should use better materials, like PETG and Siraya Blu. Few weeks after that video Siraya Tech company contacted me and they sent me Siraya Blu resin for a review. So in this video I am comparing Siraya Blu and PETG 3D printed bolts and screw nuts.
Bolts are M6x20.
PETG material: Prusament PETG orange printed on Prusa MK3s
Siraya Blu printed on Elegoo Mars and Photon S.
https://siraya.tech/

PETG dried with eSun filament dryer:
https://www.banggood.com/ESUN-Filamen...
Torque meter:
https://www.banggood.com/1_5-1000NM-D...

The previous FDM vs SLA video:
   • FDM vs SLA 3D printed bolts and nuts ...  

Results can be seen on end of each test.

Contents:
0:00 introduction
1:44 analyzing Siraya Blu bolts
3:23 analyzing PETG bolts
4:37 Tensile test - bolts
5:15 Shear test - bolts
6:29 Torque test - bolts
7:57 Pulling test - nuts
8:53 Torque test - nuts
10:07 Impact test
12:25 Temperature test
15:09 Conclusions

Support my work over Patreon:
  / mytechfun  

Or just buy me a coffee:
buymeacoffee.com/mytechfun

Support over PayPal:
https://www.mytechfun.com/donation

#sirayablu #3dprinting #siraya #petg