I got and built a new welding table/bench. I figured I'd share the build with you. I went with a CertiFlat MiniBlock table, 2 by 4 feet (from weldtables dot com). It will replace my previous CertiFlat Pro Top table from the same company. It used to be called Tab and Slot, but now it's weldtables.

I also purchased a Fab Wing and a vice mount. Even though those accessories are listed for the full size Fab Blocks, they bolt up to the mini-block just fine and end up flush with the top. The only issue is that the shoulder bolts that are included to bolt them to the table are slightly too long to bolt tight because the Fab Block is available from 1/4" and thicker, while the Mini Block is 3/16". I got some 5/8" washers, but had to grind a flat spot on them to make them fit inside, under the top. Just something to be aware of if you are looking at these tables.

Any support is appreciated. Thanks!
  / bigtb1717