Big Build Time!!!

We do a lot of package builds here at Vengeance Racing, but every now and then we have a customer that comes to us for something that is wild and allows us to show the extent of what our company is capable of.

Mr. Priest brought us his 2019 Camaro ZL1 1LE for the ultimate multi purpose build. What we mean by multi purpose is a car that is not only competitive at the drag strip, but also on the road course, as well as being comfortable for the street to go out to dinner in. In most cases, this means the car would have some compromises since we all know the best drag setup isn't the same as the best road race setup and neither make for the best street setup in most cases.

This no compromise build has achieved all of these things thanks to careful planning and execution as well as using trusted parts that work well together!

The mod list is quite extensive to say the least:

Late Model Engines LTX 427” Sleeved Aluminum Block w/ Large bore CID Cylinder Heads and Vengeance Racing Billet Valve Covers
Blueprinted Katech LT4 Wet Sump Oil Pump
Holley Dominator ECU
Magnuson TVS2650 Supercharger System
Smoothboost Boost Controller w/ PWM Control
JCD Custom “Bigger Gulp” Intake
Nick Williams 112mm Throttle Body
ToohighPSI 10 Rib Drive System
DSX Tuning Lower Pulley
Griptec 2.75 Upper Pulley
Vengeance Racing “Hyper Idler” Support System
Kooks 2” Headers w/ 3 inch X-pipe
Corsa 3” Variable Sound Exhaust
Mighty Mouse “Wild” catch can system
Lingenfelter Big Bore High Pressure Fuel Pump
Crawford Racing/ Holley Dominator Port Injection System
ToohighPSI Port Injection Plates
ID1700x Port Injectors
Radium Triple Pump Surge Tank
Aeromotive Fuel Pressure Regulator/ Filter
Dewitts Direct Fit Radiator
Vengeance Racing High Capacity Heat Exchangers
Miller Custom Fab Expansion Tank - Trunk Mounted
RTS 6XD Sequential Transmission Package
ACT Twin Street/Race Clutch System
Precision Shaft Technologies Custom Driveshaft
DSS Level 5 Rear Axles
GM A10 ZL1 Rear Differential w/ lockout kit
RPM Roll Bar
Tillet Race Seats
Schroth Harnesses
Pegasus Systems Novec 1230 Fire Suppression System
Vengeance Racing 6th Gen Camaro Parachute Kit
Forgeline GS1R Wheel Set (Drag Race Set/ Road Race set


For the heart of this car we turned to our good friends over at Late Model Engines to build us a top of the line engine to handle the big horsepower this car is set up to make. We went with their LTX 427” Sleeved Aluminum Short Block with Large Bore CID Race Cylinder Heads which have been a proven combination time and time again.

For the supercharger, we went with the popular Magnuson TVS2650 Supercharger kit with their 112mm snout to pair perfectly with the Nick Williams 112mm Throttle Body. To keep the supercharger belt making maximum grip we chose the TooHighPSI 10-Rib drive system with our Vengeance Racing Hyper Idler support system, we are super proud to say between all the dyno pulls and street pulls done on this car we used the same belt throughout the process with no belt slip.

Due to the multi-purpose nature of this build we added our SmoothBoost valve on the Magnuson 2650 supercharger. This allows us to control boost by bleeding it off through the valve, so instead of swapping pulleys to increase or decrease power it can be altered by turning the adjustment knob installed on the center console. This allows us to change the power level from 800rwhp all the way up to 1300+rwhp.

To provide adequate fueling to the engine, we went with the Crawford Racing/Holley Dominator Port injection system controlled via the Holley Dominator ECU. On a build of this power level we would typically go with a Fore Triple in tank pump system but due to the road racing this car will be doing we went with a Radium Triple Pump Surge tank to guarantee there will never be fuel starvation even in the most extreme track driving scenarios.

Something that makes this build truly special is the RTS 6XD Sequential Transmission. With a nice, light shift pull, and awesome carbon fiber shift lever, the driving experience is taken to a whole new level which leads us to say “Sequential the World”

We are super thankful to Mr. Priest for allowing us the opportunity to build this special car and show off the amazing talent our technicians possess here at Vengeance Racing!


VENGEANCE RACING
Address: 241 Castleberry Industrial Dr, Cumming, GA 30040
Phone:(678) 513-7105
Hours: 9:00 am – 5:00 pm

WEBSITE
http://www.vengeanceracing.net

FACEBOOK
  / vengeanceracing  

INSTAGRAM
  / vengeance_racing