ESP3D lets you remotely control your 3D printer. It is a little tricky to get up and running but once you have all the pieces in place it is a piece of cake. This video goes from zero to up and running so if you have no experience at all with Arduino or ESP3D you will find all you need to know. If you already use Arduino and ESP32 check the chapters below to get to where you are up to.

NOTE: I cover downloading the ESP32SSDP and WebSockets library but they are included in the ESP3D download libraries folder.

ESPCAM32 https://amzn.to/3VpHKku

0:00 Intro
0:19 Install Arduino https://www.arduino.cc/en/software
0:47 Add the ESP32 boards https://raw.githubusercontent.com/esp...
01:40 Install ESP32SSDP library https://github.com/luc-github/ESP32SSDP
02:02 Install Websockets library https://github.com/gilmaimon/ArduinoW...
02:22 Download ESP3D and unzip https://github.com/luc-github/ESP3D/t...
02:34 Download WEBUI https://github.com/luc-github/ESP3D-W...
03:20 configuration.h file for ESP32CAM https://jasonwinfield.nz/esp3d-config...
03:30 Configuration wizard https://luc-github.github.io/#/config...

Homepage: https://jasonwinfiled.nz
Patreon:   / jwinfield  
Instagram:   / jasonwinfieldnz  
Twitter:   / jasonwinfieldnz  
TikTok:   / jasonwinfieldnz  
Cults3D: https://cults3d.com/en/users/jasonwin...