This video is a 3rd match of FDM vs SLA 3D printed bolts and screw nuts and in this comparison I am using SUNLU ABS vs Siraya Tenacious and Blu mix 50-50%. I will repeat all those experiments from 2nd match (tensile-, shear- and torque test) including impact and temperature tests too.

Resin used in the video 50-50% mixture:
https://siraya.tech/products/tenaciou...
https://siraya.tech/products/blu-by-s...

1st video FDM vs SLA (PLA vs water washable resin):
   • FDM vs SLA 3D printed bolts and nuts ...  

2nd video Siraya Blu vs PETG
   • Siraya Blu vs PETG 3D printed bolts a...  

Other equipment used in video:
Prusa MK3s (for printing without enclosure)

Ender 3 V2 on banggood (affiliate):
https://www.banggood.com/custlink/GGv...
*Upgraded, all upgrades: https://www.mytechfun.com/videos/ende...

Creality small enclosure (affiliate):
https://www.banggood.com/custlink/3KK...

Digital torque wrench (smallest 0.3-30 Nm - not the same, but similar)
https://www.banggood.com/custlink/mD3...

Testing horizontally 3D printed bolts without supports:
   • Testing horizontally 3D printed bolts...  

Support my work:
https://www.buymeacoffee.com/mytechfun
  / mytechfun  
https://www.mytechfun.com/donation

Contents:
0:00 Introduction
2:43 About ABS bolts
5:29 ABS in enclosure
6:50 About Tenacious+Blu bolts
8:08 Tensile test (bolts)
8:43 Shear test (bolts)
9:13 Pulling test (nuts)
9:57 Torque test (bolts)
11:43 Torque test (nuts)
13:08 Impact test
14:59 Temperature test
16:22 Conclusions

#3dprinting #siraya #sla3dprinting #absfilament