3D Printed RC Race Boat!

This is a fun project. I did a test run and it was fast and fun. Unfortunately it was windy and choppy so I did not get a good video. I will release a test run video after the winter!

0:00
0:15 Finding the STL
0:36 3D Printed Parts
0:53 Sanding and Gluing the Parts
2:49 Prepping Surface for Paint
3:27 Glazing Putty
3:59 Epoxy Coating
5:29 After Epoxy Coating Has Cured
5:44 Filling Imperfections Before Paint
6:49 Hardware
7:04 Measuring for Motor Mount
7:33 Drill Hole for Drive Shaft
7:51 Install Rudder Assembly
8:23 Epoxy Drive Shaft in Place
8:31 Prep Surface for Motor Mount
8:42 Epoxy Motor Mount in Place
8:59 Install Servo
9:08 Finished Boat Ready for Test Run
9:26 First Test Run Coming Soon!

STL can be found here: https://www.thingiverse.com/thing:245...
Designed by thepael

Parts I used -

Brushless Motor & ESC: https://www.amazon.com/dp/B095GNR1N2?...

Flex Collet: https://www.amazon.com/dp/B09K3HGTZ5?...

Propeller: https://www.amazon.com/dp/B07JQL6LYY?...

Lipo Batteries: https://www.amazon.com/dp/B07Y56XHMK?...

Rudder & Drive Shaft: https://www.ebay.com/itm/173865062345

Motor Mount:https://www.ebay.com/itm/222902551317...