In this video I Describe how To use a ball joint press to remove and install pressed in ball joints in a lower control arm on a Ford F-150.
My Ford F-150 didn’t pass state inspection because the 2 lower ball joints were bad so I decided to change them myself to save some money. In no mechanic and ran into a few problems!
I was struggling to get the ball joints in and needed a part for the press that I did not have so I had to make something work with a piece of pipe! Oh yeah and I snapped the end of the cv joint off by Overtorquing the nut so I don’t do that!
Watch for my tips and don’t forget to comment below if you ran into the same problems

DISCLAIMER: This video and description contains affiliate links, which means that if you click on one of the product links, I’ll receive a small commission and it’s no extra cost for you! This helps support the channel and allows us to continue to make videos like this. Thank you for your support.

Ball joint press kit. https://amzn.to/2SQCFlx


Equipment I used to make this video

1 Canon 70d camera https://amzn.to/2YwLl5M

2 Rode Videomicro https://amzn.to/2GEclWV

3 Samsung 128gb micro sd card https://amzn.to/2SSb8Qy

4 Fotopro UFO 2 https://amzn.to/330kVIZ

5 lavalier lapel Microphone https://amzn.to/2YC7RKo