The original plug wires that came with these coils were way too long (since they weren't made for this car) and kinda puny, so I got some Universal cut-to length wires that seemed a bit better. This is the kit I used: https://www.holley.com/products/ignit... - lots of extras, so I also made a second "set" to have on hand in case these go bad. We will see how these work! The bummer is that I couldn't find any with the IS300 coil end type, they are pretty much all made for domestic vehicles, so I had to swap the ends over from the other original wires, which is mainly what I show in this video.
These are my coils: https://www.driftmotion.com/IS300-VVT...

I'm not sure how this is going to work yet, so if you do this too, do so at your own risk! Just wanted to show y'all how it looks. Pretty stoked on it, but still need to figure out what to do with the whole galley area to organize the wires and such.

To check out my complete list of Tools, Shop Supplies, and Parts recommendations: https://www.amazon.com/shop/fayehadley

Equipment I use for filming:
Phone: https://amzn.to/3xUkvFd
Camera: https://amzn.to/3EAuhyp
Tripod: https://amzn.to/3EBYtJr
Drone: https://amzn.to/38DgR8P

www.pistonsandpixiedust.com
IG: @pistonsandpixiedust
FB: @pistonsandpixiedust
TikTok: @FayeHadleyOfficial
Twitter: @SupraFaye