Hello everyone, welcome back to the Shed!

In this video, I am going to be removing the clutch master cylinder from my Gen 6 VFR800 VTEC and giving it an overhaul.

The master cylinder on this bike has not had any attention since the bike was new so far as I can tell, so this is one of those jobs that I really should be turning my attention to, if only to prevent a premature failure whilst out on the road!

The link to the clutch bleeding process can be found at the link below.
   • Bleeding And Replacing Motorcycle Clu...  

I bought a rebuild kit for the cylinder as I explained in the video and this can be found at the link below and it represents extremely good value in my opinion.

Master Cylinder Rebuild Kit - https://ebay.us/MMjneA

The vacuum pump that I use to bleed the system afterwards
https://ebay.us/alKJSK

All links to products are affiliate links for which I will receive a small commission on any purchase made, at no additional cost to you.

I hope that you enjoy the video.

Don't forget to like, subscribe and comment for future content from Kev's Shed!

If you wish to offer support to my channel and enable me to continue to bring you quality content then please check out my Patreon page at the following link - https://www.patreon.com/user?u=67741595 - Thank you.

Join me on the socials at the following links

Kev's Shed on Facebook -   / 561477094498994  
Kev's Shed on Instagram -   / kevins_shed  
Kev's Shed on Twitter -   / catakev79