Chamber lighting makes inspecting your prints so much easier. We add a couple of LED strips to our Voron 2.4R2 300mm using some handy mods created by the Voron community.

We chose to use the BLTouch header on our octopus for these lights as our LED header is already driving our Stealthburner in this printer.

LED Bar Clip by Eddie the Engineer - https://github.com/VoronDesign/VoronU...

Cable Covers by Jasperkm - https://github.com/VoronDesign/VoronU...

LED's used in this video -
https://www.amazon.ca/gp/product/B01N...

Chapters in this Video:

0:00 - Intro
0:12 - Remove silicone
0:20 - Prep wires / pads
0:44 - Input Wires
0:54 - Bar Clip Installation
1:25 - Output Wires
1:35 - Strip 2
2:04 - Installation into printer
2:30 - Cable Covers
2:37 - Connect to Octopus
2:42 - Update Config


Song information:

Composed by
Philip Milman ► https://pmmusic.pro/

Funded By
Ludwig ►    / ludwigahgren  
Schlatt ►    / jschlattlive