Oh boy, I had no idea that it would end up leading me into the abyss.

Help support this channel!   / needitmakeit  

I started with an Anet A8, which wasn't good, it 'worked' but not well, the Ender 3 V2 came along and I bought it, and I was really happy with it, it was a great machine for tinkering with and learning how a printer works, since then lots of new fast printers have come out and they blow the old generation of printers out of the water. Those new printers usually run a Core XY setup or a Delta, so how could a simple X Y Z cartesian setup possibly compete? Well I'm not convinced that it can, but the price is right so I wanted to try it out to see how well it performed and if there were any issues.

Some of the new printers are pretty expensive, so if the printer performs well, and the price is half or less than a Core XY, it might make sense to go that route it if does the job.

In this video we take everything apart, have a look inside, and go just about as far as we can to try and understand what's going on with this printer, how it works, as well as the good points, the bad points and some things I want to see in future versions as well.

This is a long video, because there was a bit of a struggle and I wanted to show it, hopefully you enjoy and found the difficulty I had entertaining.

Another way to support this channel indirectly is through my affiliate links (where I receive a small commission). It helps me to continue to provide high-quality content videos. Thank you for your support!

NEW MIC (I bought this)
https://amzn.to/3vcMKAr - Rode Wireless ME mic (Saved me about 4+ hours/vid)
https://amzn.to/3NBFvZe - Mag clip (Super handy, but a little pricy)

BAMBU PRINTERS
https://shrsl.com/4aghz

CREALITY PRINTERS
https://shrsl.com/4aghy

CREALITY HYPER PLA
https://shrsl.com/4aghn

#bambu
#crealityk1
#3dprinting