In this long format video I'm showing you how to design a very simple antenna winder with room for a SO-239 connector using Fusion 360.

This is not a full Fusion 360 guide, but it touches on the basic points needed to make 2D sketches, extrude them to a 3D model, adding holes and then exporting everything to an STL for 3D printing.

00:00 - Introduction
01:29 - Sketching
03:39 - Navigation
04:27 - Extrusion
04:55 - Managing history
05:36 - Toggling visibility
05:55 - Starting antenna winder design
06:17 - Main sketch
07:50 - Making construction geometry
08:16 - Drawing lines
09:47 - Fully defined sketches
10:48 - Adding a constraint
11:17 - Delete a constraint
11:46 - Adding fillets
12:47 - Warning messages
13:15 - Fillets and other dimensions
14:10 - Troubleshooting fillets
15:18 - Mirroring
17:00 - Finishing your sketch
17:16 - Extruding the winder
17:39 - Reviewing our extrusion
17:54 - Adding a second sketch
18:19 - Toggling visibility
19:40 - Adding dimensions from old sketch
21:12 - Extruded cuts
22:55 - Importing a background image
23:53 - Rotating canvas
24:08 - Scaling canvas
25:00 - Placing canvas
25:55 - Sketching off a canvas
26:23 - Creating a hole pattern
27:20 - Equal constraint
29:20 - Extruding the SO239
29:44 - Using a shared sketch
30:22 - Adding a solid fillet
31:15 - Deleting solid fillets
31:37 - Adding surface fillets
32:12 - Exporting for 3D printing
33:29 - Thoughts on iterative design
34:01 - Next steps
34:34 - Share what you make