How to SELF bleed / flush brake fluid for a 1995-2004 Toyota Tacoma and 4Runner. Also similar process applies to T100 and Tundra!

Tool List:

- 10mm flare nut wrench
- ⅜” diameter clear tube
- 64oz clear bottle (preferably with a top)
- (2) 32oz DOT3 brake fluid
- catch pan
- jack stands
- (4) bleeder screw rubber cover

Brake Bleed/Flush Sequence:

- Rear passenger brake caliper
- LSPV (load sensing proportioning valve) NO need to bleed from here :)
- Rear driver brake caliper
- Front passenger brake caliper
- Front driver brake caliper

*If the video was helpful, remember to give it a "thumbs up" and consider subscribing.*

Disclaimer:
Due to factors beyond the control of Engineered Mojo, I cannot guarantee against improper use or unauthorized modifications of this information. Engineered Mojo assumes no liability for property damage or injury incurred as a result of any of the information contained in this video. Use this information at your own risk. Engineered Mojo recommends safe practices when working on vehicles and or with tools seen or implied in this video. Due to factors beyond the control of Engineered Mojo, no information contained in this video shall create any expressed or implied warranty or guarantee of any particular result. Any injury, damage, or loss that may result from improper use of these tools, equipment, or from the information contained in this video is the sole responsibility of the user and not Engineered Mojo.