Many people forget to line up the torque converter with the trans oil pump before reinstalling the transmission. This causes the transmission pump prongs to shear. This also makes it hard to reinstall the transmission since there will be a gap between the bellhousing and the engine. Few other things to do before reinstalling your automatic transmission:
Check alignment dowels, replace seals, replace filter and pan gasket, flush out transmission cooler lines, clear out any mounting bolt threads, replace engine and transmission mounts, replace rear main seal, clean out starter dowels/alignment pins, driveshaft center support bearing and flex joint. Hope this quick tip video helps out!

Support my channel by becoming a member using this link:    / @shoplifetv  

My Amazon Store: https://www.amazon.com/shop/shoplifetv

Buy My Merchandise: http://www.shoplifetv.com
Ask me a question: http://www.shoplifetv.com
Request a Shop Appointment: http://www.shoplifetv.com

Instagram: @ShopLifeTV
  / shoplifetv  

My vlog channel:    / shoplifevlogs  

Youtube Business Inquires: Email me [email protected]

Disclaimer: Some links will contain affiliate links. Due to factors beyond the control of ShopLifeTV, I cannot guarantee against improper use or unauthorized modifications of this information. ShopLifeTV assumes no liability for property damage or injury incurred as a result of any of the information contained in this video. Use this information at your own risk. ShopLifeTV recommends safe practices when working on vehicles and or with tools seen or implied in this video. Due to factors beyond the control of ShopLifeTV, no information contained in this video shall create any expressed or implied warranty or guarantee of any particular result. Any injury, damage, or loss that may result from improper use of these tools, equipment, or from the information contained in this video is the sole responsibility of the user and not ShopLifeTV.