Thanks to PCBWay for sponsoring this video. Check out https://www.pcbway.com/ for custom printed circuit boards, electronics, and rapid prototyping services (Use my referral link to get $5 of New User Free Credit) https://www.pcbway.com/setinvite.aspx... !

Hiya, again! Building a water-lovin' FirstPersonView drone has been a bit of an obsession of mine, and I'm always getting a little closer to it! So today I'm testing a flotation setup and waterproofing quality for this 7" FPV drone. This didn't go smoothly, but it was an excellent, educational testing session. My mind is tingling with different design ideas to try. Most importantly, the waterfoofing seems to be holding up well (yes, I know I misspelled waterproofing, but it sounds so funny I left it that way. Pro tip: make sure your antennas stay ABOVE the water when it's floating!

00:00 Hello, Friend. BLUF.
2:32 Our watery adventure begins early in the morning
3:47 Turtlemode / Flip over after crash mode behavior
4:29 First flight
7:24 2nd flight
10:30 3rd flight (almost killed the camera guy)
17:11 4th flight


-------------
🧠 FREE RESOURCES, 3D Printable Designs, and more for FPV Drones, RC Aircraft & 3D Printing at http://rcwithadam.com/

Want to support RCwithAdam? ↴
KO-FI: https://ko-fi.com/rcwithadam
OR
PATREON:   / rcwithadam  
Thanks!

-------
Mandatory Affiliate Disclaimer:
Any links in this description may be affiliate links, which means I make a very small commission (at no additional cost to you) when you make a purchase through that link.
*DISCLAIMER: Remember to always use caution and your best judgement when building and flying RC aircraft, and when working with 3D printers, electronics, or electrical devices. Be mindful of the laws, regulations, and best practices for your particular location. Be a good neighbor, and HAVE FUN!*
-----------
About RCwithAdam: Adam's goal is to HELP YOU build your skills and eliminate frustration and confusion through creative, educational, and encouraging videos featuring Radio Control airplanes, FPV drones, electronics, and 3D printing!
#RCwithAdam #fpvdrone #DJI