Complete bathroom shower install time lapse start to finish
Sal DiBlasi Sal DiBlasi
199K subscribers
3,946,037 views
0

 Published On Jul 14, 2013

SUBSCRIBE Learn how tile the right way
Complete bathroom shower install time lapse start to finish. Including pre slope, vinyl shower liner, cement board, recesses niche, waterproofing, wood look plank porcelain tile, and grouting.
A pre pitch or pre slope    • How to install a shower pre slope or ...   under a shower pan liner is an essential part of a successful tile shower installation. A pre slope is the base under the shower pan liner which is pitched so that the any water that manages to get into the shower base can be directed to the weep holes in the three piece drain and out of the liner. If a pre slope is not installed under the liner then any water that filters into the base of the shower will remain there. To install a pre slope on a concrete base first spread a thin layer of thinset with a notched trowel, while it is still fresh, the deck mud is then shaped on top of the thinset so that there is a slope of ¼" per foot sloping towards the drain. The part of the base furthest away from the drain will be higher than the drain, so as to create a positive pitch towards the drain. How to install a vinyl shower liner. When installing a vinyl liner for the pan of a shower floor,    • How to install a vinyl shower pan liner   it is imperative that any penetrations to secure the liner be above the level of the shower curb. Also the folds at the corners of the shower should always be done without cutting the liner lower than the shower curb. I do not install dam corners on the curb, because I apply a liquid waterproofing membrane on the surface of the entire shower stall, or at the very least the curb will be thoroughly waterproofed to avoid leeks in this critical area if this step is to be omitted, the dam corners should be used. The silicone bead at the drain where the liner is clamped to the 3 piece drain should always be applied, do not skip this step. How to install mud in a shower pan for a tile shower stall.    • How to install   Mud in a shower floor   When installing a tile shower, whether it be ceramic, marble travertine or any other tile product, a mud base will be required. Mud also known as deck mud, is a mixture of sand and Portland cement mixed to a ratio that will create a solid foundation for the tile which will be installed on it. The deck mud is mixed with water to a dump consistence which will allow the deck mud to hold its shape when pressed into a ball. The mud must be pitcher towards the drain so that a slope of at least ¼" per foot is achieved. The ratio of sand and Portland cement is usually 4:1 or 5:1. I usually use "Quikrete" sand topping mix, which as far as I know, has a ratio which is a little richer than needed, but is suitable for a shower pan. The method I employ to install my mud in shower pan, is to create a level and flat perimeter around the base of the shower walls which is at the correct height in relation to the drain, and then fill the middle part of the shower pan screeding down to the drain with the proper pitch. The mud is shaped with a wooden trowel, steel trowel, level and other pieces of straight wood lengths cut to the required lengths. In this video I demonstrate the technique I use to install a shower mud pan base. There are other methods that can be used, but this is the way I have installed hundreds of shower bases.
I hope anyone that watches this finds it helpful.
All tile installed by Sal DiBlasi, Elite-tile Company, in the Boston North Shore area. This video contains affiliate links, which means I will receive a small commission if you click on the product link.


☕ Buy me a coffee ☕
https://www.buymeacoffee.com/saldibs2

🙂 This is my Amazon Store 🙂 https://www.amazon.com/shop/saldiblasi

💲 PDF Floor installation guidelineshttps://sowl.co/s/wWd2d 💲

👍 Patreon   / saldiblasi   👍

YouTube Channel
http://www.youtube.com/user/saldibs?f...

Products available at
https://www.amazon.com/shop/saldiblasi

Facebook
  / 56681633342  

Website
http://www.elitetileco.com/

Twitter
  / saldiblasi1  

Instagram
  / saldiblasi1  

National Tile Contractors Association
https://tile-assn.site-ym.com/
👇 Some of my favorite Tools 👇
Float https://amzn.to/2tdEpN2
Rubbing Stone https://amzn.to/2QrgRfh
Notched Trowel 1/4 x 1/4 x 1/4-inch https://amzn.to/36bq5mQ
Notched Trowel 1/2 x 1/2 x 1/2-Inch https://amzn.to/2Q5e90g
Notched Trowel 1/4 x 3/8 x 1/4-Inch https://amzn.to/39j1caB
Super Dust Collector – WaleTale https://amzn.to/2MDuVkK
Black Nitrile Gloves - 6 mil https://amzn.to/2SJQ6FZ
Margin Trowel https://amzn.to/352MYHx
Mortar Mixer https://amzn.to/2ZxYqtF
4in Sandpaper for Stone Polishing https://amzn.to/2ZB2skT
Polishing Rubber Backing Pad https://amzn.to/2srikdy
Montolit 63P3 24 Inch Tile Cutter https://amzn.to/2MDoFtl
DEWALT Wet Tile Saw https://amzn.to/2QqpO8O
Rubi Thinset mixer https://amzn.to/39VmNWV
For Industry Professionals only

show more

Share/Embed