Creality CR6-SE Review - Pass or Fail
Tripods Garage Tripods Garage
32K subscribers
51,649 views
0

 Published On Sep 24, 2020

#Creality #Review #3DPrinting
I purchased the new Creality CR6-SE 32Bit 3D Printer from Creality. This printer out of the box has a lot of the features I was looking for my next 3D Printer. Is this $400 USD printer worth it? Are there any problems with it? Watch and find out!

Thanks to Sebastiaan Dammann - CR6-SE Issue List
https://gist.github.com/Sebazzz/ff4d7...

Harbor Freight workbench -https://www.harborfreight.com/60-in-4...

Disclaimer - This is an instructional video only - I assume no responsibility if you do not become a pro after watching this video. This video is for learning purposes only, you are following the steps in this video at your own risk!

  / tripodsgarage  
  / tripodsgarage  
  / tripodsgarage  

Thanks for watching - Please Like and Subscribe!


Tags
CR6-SE, CR6SE, 32-Bit Control Board, TMC2209 Stepper Motor Driver, 3D Printer, 3D Printing, CR-10, CR-10s, Ender 3, Ender 3Pro, Ender 5 Pro, Ender 5, creality silent board, silent board,

show more

Share/Embed