In today's episode I'm doing a deep dive into Fusion 360 and the design of the 3D Printed Gauge Cluster for my Datsun 280z. Between laser cutting and 3D printing, I'm hoping to come up with something unique that unmistakably belongs in a z-car, and will be a showpiece for the interior.

Save 15% off an order with SendCutSend: http://sendcutsend.com/grindhouse

General Links:
Video Camera: https://amzn.to/3hh16np
Microphone: https://amzn.to/3j3dyrB
DSLR: https://amzn.to/3heNFEw
Merch: https://www.grindhouseperformanceshop...

Chapters:
00:00 Past and Present Z-Series Interiors
01:16 Design Goals / Introduction
01:43 Designing the Lens Hood
04:53 Check Engine Light
05:45 Back Halves of the 3D Prints
06:48 Mounting Tabs for Rear Grates
08:20 Dimmer Switch
09:32 Triple Gauge Design
11:03 CAN Keyboard Mounting
12:37 Laser Cut Frame
17:49 Finishing the Triple Gauge Prints
19:46 Routing all the Wires

Get Build Updates Before YouTube by Following me on Instagram:   / grindhouse.performance  

As an Amazon associate I earn from qualifying purchases (paid link).

WARNING: This video is only for entertainment purposes. If you rely on the information portrayed in this video, you assume the responsibility for the results. Have fun, but always think ahead, and remember that every project you try is AT YOUR OWN RISK.