removing and replacing dshaft coupler and driveshaft support bearing! now i start the process of removing exhast and than removing bolts from drive shaft from transmission than i loosin the bolts from heat shield covering d shaft and i do the same at differential but remember to mark your d shaft where it bolts before removing it ! than i hit the old bearing out with my prybar flat end on bearing than i move on to reinstalling bearing but make sure you remember which side the housing sits before removal and then i use my jack handle with a lil bit of grease to slide on easy and than i remove the coupler and reinstall new one on trans and basically reverse your steps! i did this in about a hour.
thanks for watching not the best but its a basic removal and reinstall..... as i get better at editing videos will come out better..