Hi, I know it's been awhile since i've posted last. but I've been busy, plus this project took a lot of research and fabrication. So the table has 3 axis, x, y and z. there are two stepper motors that run the x axis, and one for both y and z. I'm using an Arduino mega with GRBL which is an opensource CNC program that is compatible with all kinds of homemade machines. I am also using universal G-Code sender to send my designs as code, to the Arduino. I glossed over many parts of the project in the video, so if you have questions be sure to ask.




Here is some of the purchased equipment I used for this build:


Emergency stop: https://www.amazon.com/dp/B07R8PTTDX?...


End Mills: https://www.amazon.com/dp/B08CD99PWL?...


PWM to Voltage Converter: https://www.amazon.com/dp/B07BDK8QDG?...


Cable Wire Carrier: https://www.amazon.com/dp/B07QXJSS9V?...


Terminal block for Arduino Mega: https://www.amazon.com/dp/B07H9TJCWN?...


Connectors: https://www.amazon.com/dp/B0829Y7TGS?...


Elegoo Mega (Arduino Clone): https://www.amazon.com/dp/B01H4ZLZLQ?...


5mm to 8mm coupler: https://www.amazon.com/dp/B07P82D36N?...


Brushless DC Spindle Kit: https://www.amazon.com/dp/B083XQ9NF1?...


Aluminum Belt Pulley's: https://www.amazon.com/dp/B0747QJGYT?...


Linear Rails: https://www.amazon.com/dp/B08BRBRTJT?...


Stepper Motor CNC Kit ( I did not use the CNC board Provided): https://www.amazon.com/gp/product/B07...