Adjusting the toe-in angle on a CAMSO ATV/UTV track system is important for ensuring proper steering and handling. The toe-in angle refers to the angle between the front edges of the tracks and is measured in degrees.

To adjust the toe-in angle on a CAMSO track system, follow these steps:

Ensure that the vehicle is on level ground and that the tracks are properly tensioned.

Locate the adjustment bolts on the front and rear of the track system. These bolts are typically located on the pivot point of the track system.

Loosen the adjustment bolts on both sides of the track system.

Use a tape measure to measure the distance between the front edges of the tracks at the midpoint of the track system.

Adjust the toe-in angle by turning the adjustment bolts. To increase the toe-in angle, tighten the adjustment bolts on the front of the track system and loosen the adjustment bolts on the rear of the track system. To decrease the toe-in angle, loosen the adjustment bolts on the front of the track system and tighten the adjustment bolts on the rear of the track system.

After making the adjustment, re-measure the distance between the front edges of the tracks to ensure that the toe-in angle is within the recommended range for your vehicle.

Tighten the adjustment bolts to the recommended torque specification.

Test drive the vehicle to ensure that the steering and handling are properly adjusted.

It is important to note that the recommended toe-in angle can vary depending on the make and model of your vehicle, as well as the specific CAMSO track system that you are using. Be sure to consult the owner's manual or contact CAMSO for specific recommendations on adjusting the toe-in angle for your vehicle and track system.