Follow my step by step guided tour on how to make these vacuum suction hold down clamps that can easily be attached to your workbench. You can make these at home without having a CNC machine and achieve professional looking and working results. These vacuum hold down clamps work using a small and cheap to run vacuum pump. You can use a variety of materials to make these and with the aid of a hand held router trimmer, machine your way to a great addition to your home or professional workshop.

Affiliate Links:

PVC Foam Board (3/4" - 8" x 10"):
https://amzn.to/3S9Lszr

https://trademaster.com.au/product/wh...
https://www.nover.com.au/prolight-pre...

Round Rubber Seal:
https://amzn.to/3wZqPdE

Router Cutter to Suit 6mm Seal:
https://amzn.to/3ZHThNT

Pneumatic Fitting Push-In 1/4” x 8mm:
https://amzn.to/40qSBxj

Pneumatic Tube 8mm x 5m:
https://amzn.to/45GOyy3

Vacuum Pump (NOTE: NOT THE SAME PUMP AS I PURCHASED BUT SIMILAR! - check the pump has your countries power-point plug):
https://amzn.to/495AeSy


Pneumatic Foot Pedal:
https://amzn.to/3HCUyxL

Inline Filter (to help catch any dust going into machine):
https://amzn.to/3reWhVu

Microjig Matchfit Clamp Set:
https://amzn.to/3jySpLD

Pneumatic Vacuum Generator (works with your air compressor - optional):
https://amzn.to/3YoJIT4