This video provides a short training on the T-Square oral fluid instant testing device. This product is available from Nexscreen and has multiple drug configurations including AMP, BAR, BZO, COC, MDMA, MET, MTD, OPI, OXY, PCP, BUP and THC.
Four easy steps for oral fluid collection with the T-Square oral fluid testing device.
1. Remove the test cube and the sponge collector from the foil pouch by tearing at the notch. Place the test cube upright on a level surface.
2. Put the sponge end of the collector in your mouth to collect oral fluid for about 7 minutes or until the sponge is fully saturated by oral fluid. Do not chew, bite or suck the sponge. If the amount of oral fluid does not make the sponge fully saturated within 7 minutes, repeat the collection using one additional sponge collector provided, beginning with Step 1. Note: In case of dry mouth, do not swallow oral fluid during collection.
3. Open the test cube and place the fully saturated sponge collector inside the test cube. Press the sponge collector down firmly until it reaches the bottom of the test cube, then close the cube lid tightly while compressing the collector. Keep the test cube upright on a flat surface and follow Step 4. Note: Make sure the sponge collector is inserted vertically and the handle of collector is put into the clamp of the dry mouth, do not swallow oral fluid during collection
4. Interpreting Drug Test Results: Read results at 5 minutes. Do not read after 5 minutes.
There is a short window of detection for oral fluid testing, usually up to two days from ingestion for most of the drugs of abuse.
It is important to understand that with instant oral fluid device drug testing, a negative result is accurate. Non-negative results must be sent to a laboratory for confirmation and then results reviewed by the Medical Review Officer (MRO).