How To Drill Holes Into The Greywater Aquifer Pipe
In this video we're going to be showing you how to drill the seep holes.
This is the first step when you're installing the Aquifer Pipes. They are drilled on the both sides of the inner wall with a ¼ drill bit. It’s best to do this on a hard concrete surface this helps prevent the drill bit from going all the way over to the other side. The holes are placed about ¼ inch to 1/8th inch from the bottom. About one foot to ten inches apart. They don't have to be exact just randomly down both sides of the Aquifer Pipe.

Next thing you want to do is clean it, remove all the debris from the pipe. If there's any plastic hanging on the holes you especially want to remove that because if any hair, lint or anything gets caught on there it will plug up that hole.

If you do go to the other side we have a video on how to repair the Aquifer Pipe
   • How To Repair The DIY Greywater Aquif...  

The Complete DIY Greywater Install Guide
https://bit.ly/2wQSRww

DIY Greywater How To Tutorials
http://bit.ly/2t46Bln

Greywater Playlist
http://bit.ly/377ovCo

For More Information visit:
https://grey4green.com
Or call: 213-885-4122

BUY at Lowes
http://bit.ly/379ndXq

#ClimateChange #GlobalWarming #Greywater