If your printer bed looks more like a slip-n-slide, this is the video for you!

Help support this channel!   / needitmakeit  

In this video we first show the recommended way to level the bed, and yes it was better, but not nearly good enough. We have come up with a far better and easier way to do it from the top. If your bed was better than mine, you can use the method I came up with, but if it's worse, you probably want to do the same process as shown in the video.

There is a possible alternate method to get it close called the 'Tooth-skipping' method, but I've never tried it and I think it is a job better suited for two people.

I hope you found this video helpful and interesting!

Another way to support this channel indirectly is through my affiliate links (where I receive a small commission). It helps me to continue to provide high-quality content videos. Thank you for your support!

NEW MIC (I bought this)
https://amzn.to/3vcMKAr - Rode Wireless ME mic (Saved me about 4+ hours/vid)
https://amzn.to/3NBFvZe - Mag clip (Super handy, but a little pricy)

BAMBU PRINTERS
https://shrsl.com/4aghz

CREALITY PRINTERS
https://shrsl.com/4aghy

CREALITY HYPER PLA
https://shrsl.com/4aghn

Download spacers:
https://www.printables.com/model/6815...
https://makerworld.com/en/models/92567

#creality
#crealityk1
#klipper