In this video I am going to show you how to make a USB load tester, which is very useful device to check current and voltage consumption of your USB powered devices.

*Circuit Diagram was included in the video. (Follow that Diagram)

You need:
1) Panel Voltmeter/Ammeter - https://ebay.to/2W9RVhh
2) USB Type A Female connector x1 - https://bit.ly/2HoYxQQ
3) USB Type A Male connector x1 - https://ebay.to/2w4nTwG
4) 10W 5 Ohms Resistor x2 - https://ebay.to/2PWMQSO
5) 220 Ohms resistor x4 - https://ebay.to/2LO6VgX
6) 5mm LED 3V x2 - https://ebay.to/2HnBBkR
7) 2Pole 2Position 6Pin Switch x2 - https://ebay.to/2EeiS9u
8) Dual side Perf board (2cmx 8cm) x1 - https://ebay.to/2YzJlpA
9) Some Quality wires

Thank you.
Subscribe for more future creative project videos.
Subscribe LahisTech: https://bit.ly/2JHtlyc

____________________________Music______________________________
Song: Fredji ft. Arcade - Ocean (Vlog No Copyright Music)
Music promoted by Vlog No Copyright Music.
Video Link:    • Fredji ft. Arcade - Ocean (Vlog No Co...  

Coconuts by MBB   / mbbofficial  
Creative Commons — Attribution-ShareAlike 3.0 Unported — CC BY-SA 3.0
http://creativecommons.org/licenses/b...
Music promoted by Audio Library    • Coconuts – MBB (No Copyright Music)