Those tight bends MUST be causing print defects right?
Help support this channel!   / needitmakeit  

This one was suggested by a viewer and it's a question I've had for several years, does the friction inside the tube cause the extruder to produce an inconsistent result? Before starting the testing, I was pretty sure that with such a tight bend in the tube and with the tube in the cable chain, the extruder must be having trouble. But if that were the case, why would Creality design it this way, is it a bad decision or do they know something that we don't?

I hope you found this video helpful and interesting!

Another way to support this channel indirectly is through my affiliate links (where I receive a small commission). It helps me to continue to provide high-quality content videos. Thank you for your support!

NEW MIC (I bought this)
https://amzn.to/3vcMKAr - Rode Wireless ME mic (Saved me about 4+ hours/vid)
https://amzn.to/3NBFvZe - Mag clip (Super handy, but a little pricy)

BAMBU PRINTERS
https://shrsl.com/4aghz

CREALITY PRINTERS
https://shrsl.com/4aghy

CREALITY HYPER PLA
https://shrsl.com/4aghn

#creality
#crealityk1
#klipper